SENT Driver API - National Instruments NI LabVIEW FPGA Driver for SENT Protocol

  • SENT master
  • LabVIEW FPGA API provided
  • Compatibility with LabVIEW 2010 or later
  • Download
The SENT Driver API provides the NI LabVIEW FPGA code for the Single Edge Nibble Transmission (SENT) protocol communication engine. You can use this driver to communicate with SENT transmitters as a SENT receiver when you connect SENT transmitters to hardware with FPGA digital I/O lines. This driver works with NI Single-Board RIO hardware and NI 940x C Series modules.

Note: You must use JKI VI Package Manager to install this driver. Select Tools>>Options to Disable the Mass Compile VIs After Package Installation option in the VI Package Manager before you install this driver for LabVIEW 2010 or later.

Support Information
For technical support, post questions on the NI Forums at

Disclaimer: This example program (this “program”) was developed by a National Instruments (“NI”) Engineer. Although provided by National Instruments, this program may not be completely tested and verified, and NI does not guarantee its quality in any way or that NI will continue to support this program with each new revision of related products and drivers. THIS PROGRAM IS PROVIDED “AS IS” WITHOUT WARRANTY OF ANY KIND AND SUBJECT TO CERTAIN RESTRICTIONS AS MORE SPECIFICALLY SET FORTH IN NI.COM'S TERMS OF USE (

Additional Product Information