From 09:00 PM Friday, August 7 - 10:30 AM CST Saturday, August 8, ni.com will be undergoing system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

WF 3144 Programmable Resistor Driver by WireFlow AB Driver for WF 3144 C-Series Programmable Resistor Module

  • 4 separate programmable resistor channels
  • Resistive sensor simulation: pressure sensors, thermistors, RTDs, and so on
  • Seamless integration in LabVIEW FPGA
  • Use 2 channels together for high-accuracy mode
  • Replace manual potentiometers
  • Download
Use the WireFlow WF3144 Programmable Resistor Driver in NI LabVIEW software to interact with the WF 3144 C-Series module from WireFlow. The module is a 4-channel, 16-bit programmable resistor for NI CompactRIO hardware. It uses an array of real resistors switched to the desired resistance with solid-state relays. Each channel is galvanically isolated, making it ideal for sensor simulation. The 16-bit resolution is nonlinear with finer steps at lower resistance values. It can, for example, be used to emulate a PT100 sensor with a range of 40 Ohm to 180 Ohm and -150 °C to +200 °C with a resolution of 0.1 °C.

Support Information
This product is provided by a third-party and not supported by National Instruments. For technical support, contact WireFlow at:
Email: support@wireflow.se
Web: wireflow.se

Disclaimer: The Third-Party Add-Ons for LabVIEW on this page are offered by independent third-party providers who are solely responsible for such products. NI shall have no responsibility whatsoever for the performance of the Third-Party Add-Ons.