Ingenia Motion Control Library - Ingenia Motion Control Interface LabVIEW With Motor Control API

  • Connection: Connect to and disconnect from a CANopen network and its drives
  • Motion: Enable/disable motor, trajectory generator, homing, position, interpolation, and so on
  • I/O: Get and set digital and analog inputs and outputs of an Ingenia motion controller
  • Download
The Ingenia Motion Control Library for NI LabVIEW uses the CANopen standards CiA301 and CiA402 to work as a network command source.

The library allows for movements using Ingenia digital servo drives connected to DC, stepper, BLDC, or BLAC motors.

Ingenia VIs
-Connection: Connect to and disconnect from a CANopen network and its servo drives
-Motion functions: Enable/disable motor, trajectory generator, homing, position, interpolation, and so on
- I/O: Get and set digital and analog inputs and outputs of an Ingenia motion controller

Supported Hardware
-NI 9881 one-port, high-speed CANopen C Series module interface
-NI PXI-8531 one-port, high-speed CANopen PXI interface
-NI PCI-8531 one-port, high-speed CANopen PCI interface

Support Information
For technical support, contact Ingenia Motion Control:
Email: technical@ingeniamc.com
Web: ingeniamc.com/En/Soporte/Soporte-Tecnico.aspx

Disclaimer: The Third-Party Add-Ons for LabVIEW on this page are offered by independent third-party providers who are solely responsible for such products. NI shall have no responsibility whatsoever for the performance of the Third-Party Add-Ons.