|Form Factor||PXI Platform|
|PXI Bus Type||PXI Hybrid Compatible|
|Part Number||778768-02 , 779670-02|
|Synchronization Bus (RTSI)||No|
|I/O Connector||SMA female|
|Power Requirement for +3.3V Rail||0.4 A|
|Power Requirement for +5V Rail||0.5 A|
|Power Requirement for +12V Rail||0.52 A|
|Power Requirement for -12V Rail||0.08 A|
|Slot Two Module||No|
|RF Product Type||RF Signal Transceivers|
|Minimum Frequency||500 kHz|
|Maximum Frequency||6.6 GHz|
|Output Impedance||50 Ohm|
|On-Board Memory||1024 bits|
|Waveform Types||Intermediate Frequency , RF|
|Provides Data Bit Marker?||No|
|Supports Linking/Looping Segments?||No|
|Supports Frequency Hopping and Sweeping?||Yes|
|Real-Time Bandwidth (RF only)||8 MHz|
|Noise Floor (@ -50 dBm output)||-140 dBm/Hz|
|Phase Noise||-110 dBc/Hz|
|Supports Data Streaming?||No|
|Supports On-the-fly signal adjustments?||Yes|
|RF Power Range||-100 dBm - 10 dBm|
Reduce your setup time and total cost of ownership, and get a system you can use out of the box with National Instruments system assurance programs. System assurance programs include:
This service is only available for PXI, NI CompactRIO, and NI Compact FieldPoint systems.
National Instruments designs and manufactures all products to minimize failures, however unexpected failures can still occur. Extended warranties provide a fixed economical price at the time of system purchase, covering any repair costs for up to three years. In addition, they offer the following benefits:
For more information about your warranty options:
NI recognizes the need to maintain properly calibrated devices for high-accuracy measurements. NI provides manual calibration procedures, services to recalibrate your products, and automated calibration software to calibrate many NI measurement products.
NI training is the fastest, most certain route to productivity with NI tools and successful application development.
Return your registered product under warranty at no additional labor and parts cost. NI offers fault location, diagnostics, and repair any time the system fails as well as any adjustments needed to restore the hardware to manufacturing specifications.