The National Instruments 9237 simultaneous bridge module for use with NI CompactDAQ and CompactRIO contains all the signal conditioning required to power and measure up to four bridge-based sensors simultaneously. The four RJ50 jacks provide direct connectivity to most torque or load cells and offer custom cable solutions with minimal tools. The high sampling rate and bandwidth of the NI 9237 offer a high-quality, high-speed strain or load measurement system with zero interchannel phase delay. With 60 VDC isolation and 1,000 Vrms transient isolation, the NI 9237 has high common-mode noise rejection and increased safety for both the operator and test system.
The NI 9237 can perform offset/null as well as shunt calibration and remote sense, making the module the best choice for strain and bridge measurements.
The NI 9944 and NI 9945 are accessories for use with quarter-bridge sensors. These accessories have a female RJ50 connector on one end and screw terminals on the other end. Purchase these accessories with a kit of RJ50 cables (qty 4).
For screw terminals without the quarter-bridge completion, purchase the NI 9949 and a kit of RJ50 cables (qty 4). This setup exposes all 10 pins for each channel as screw terminals.
Reduce your setup time and total cost of ownership, and get a system you can use out of the box with National Instruments system assurance programs. System assurance programs include:
Installation and integration test of all individual hardware
Courtesy installation of system driver sets and application development environments
Extended warranty and calibration coverage for up to five years
Custom documentation plus a custom restore and startup utility
This service is only available for PXI, NI CompactRIO, and NI Compact FieldPoint systems.
National Instruments designs and manufactures all products to minimize failures, however unexpected failures can still occur. Extended warranties provide a fixed economical price at the time of system purchase, covering any repair costs for up to three years. In addition, they offer the following benefits:
Significant cost savings compared to individual repair incidents
Fault location, diagnostics, and repair by NI any time the system product fails
All parts and labor costs covered as well as any adjustments needed to restore the hardware to manufacturing specifications
NI recognizes the need to maintain properly calibrated devices for high-accuracy measurements. NI provides manual calibration procedures, services to recalibrate your products, and automated calibration software to calibrate many NI measurement products.
Return your registered product under warranty at no additional labor and parts cost. NI offers fault location, diagnostics, and repair any time the system fails as well as any adjustments needed to restore the hardware to manufacturing specifications.
Honeywell and National Instruments have been working together to provide an easier setup and system configuration experience for our customers. These efforts have resulted in Honeywell offering a wiring/connectivity option for many of their sensors that will directly connect to the NI 9237 module. For more information regarding this partnership, see below:
