Academic Company Events NI Developer Zone Support Solutions Products & Services Contact NI MyNI

SCXI-1163R

  • 32-Channel Optically Isolated Solid-State Relays
  • Eight banks of 4x1(1-wire) multiplexers
  • Switching capacity of 200 mA at 240 VDC/Vrms
  • Fully software programmable
  • Operating speed of 750 cycles/s
  • Data Sheet  |   Configure System popup

Part Number Description Est Ship  US Dollars Qty
Common Configuration
776572-63RSCXI-1163R 32 ch Solid-State Relay Module--For prices, Select Country 
777687-26SCXI-1326 High-Voltage Screw Terminal Block, Cast--For prices, Select Country 
 
 

Please select the country where you will use the product(s) so that we can provide you with accurate pricing, availability, and purchasing information

The SCXI-1163R includes 32 normally open, or Form A, optically isolated solid-state relays, arranged into eight banks of four relays with one common pole for each bank. You can use the SCXI-1163R to switch high-voltage loads, up to 240 VAC/VDC and up to 200 mA. The SCXI-1163R is programmed serially over the SCXIbus. You can therefore easily integrate SCXI-1163R modules into existing SCXI systems without additional DAQ devices or cabling. The modules can operate in parallel mode when cabled directly to a plug-in DIO device.

Specifications Documents


Specifications Summary

General 
Form FactorSCXI
OS SupportWindows, Real-Time, Linux
LabVIEW RT SupportYes
Switch TypeMultiplexer
Relay TypeSSR
ConnectivityTerminal Block
Product CertificationsC-Tick, CAN/CSA, CE, FCC Part 15, IEC, UL - Product Safety
Input Characteristics 
Multiplexer Configurations8 banks of 4x1, 1-wire
Maximum Switching Voltage DC (Pollution Degree 2)240 VDC
Maximum Switching Voltage AC240 Vrms
Maximum Switching Current200 mA
Maximum Carry Current200 mA
Maximum Switching Power48 W
Bandwidth1 MHz
Relay Count TrackingNo
Voltage CategoryCAT II
Path Resistance (Typical)8 Ohm
Dynamic Characteristics 
Scan Rate750 cycles/s
Timing/Triggering/Synchronization 
Synchronization Bus (RTSI)Yes
TriggeringDigital
External ClockingNo
Physical Specifications 
Length19.8 cm
Width17.3 cm
Height3 cm
I/O Connector48-pin DIN

Extended Warranties

National Instruments designs and manufactures all products to minimize failures, but we know unexpected failures can still occur. Extended warranties provide a fixed economical price at the time of system purchase covering any repair costs for up to three years.

  • Significant cost savings compared to individual repair incidents
  • Fault location, diagnostics, and repair by NI any time the system product fails
  • All parts and labor costs covered as well as any adjustments needed to bring the hardware back to manufacturing specifications

Calibration

NI recognizes the need to maintain properly calibrated devices for high-accuracy measurements. We provide manual calibration procedures, services to recalibrate your products, and automated calibration software to calibrate many of our measurement products.

Training

NI training is the fastest, most certain route to productivity with NI tools and successful application development.

Repair Services

  • You can return your registered product under warranty at no additional labor and parts cost. NI offers fault location, diagnostics, and repair any time the system fails as well as any adjustments needed to bring the hardware back to manufacturing specifications.
  • Contact us to obtain a Return Material Authorization (RMA) form and shipping instructions
  • View your RMA support request status online
  • Register your product

Technical Support

www.ni.com/support