National Instruments offers a variety of 32-channel analog input modules for SCXI, including the SCXI-1100, SCXI-1102 Series, and SCXI-1104 Series. The programmable gain and filter settings are ideal for conditioning a variety of millivolt, volt, and current inputs. Each module multiplexes the 32 channels into a single channel of the DAQ device, and you can add modules to increase channel count.
An SCXI chassis is required to house the SCXI modules. The NI SCXI-1000 chassis can hold up to four modules while the NI SCXI-1001 can hold up to 12. You can choose NI X Series, M Series, E Series, or S Series DAQ modules for controlling the chassis.
Open thermocouple
,
Cold-junction compensation
,
Low-pass filtering
,
0-20 mA current input
Analog Input
Channels
0
,
32
Single-Ended Channels
0
Differential Channels
32
Sample Rate
333 kS/s
Max Voltage
10 V
Maximum Voltage Range
-10 V
-
10 V
Minimum Voltage Range
-100 mV
-
100 mV
Simultaneous Sampling
No
Input Impedance
1 GOhm
Available Filters
200 Hz
Analog Output
Channels
0
Digital I/O
Bidirectional Channels
0
Input-Only Channels
0
Output-Only Channels
0
Counter/Timers
Counters
0
Physical Specifications
Length
18.8 cm
Width
17.2 cm
Height
3 cm
I/O Connector
Screw terminals
Minimum Operating Temperature
0 °C
Maximum Operating Temperature
50 °C
Minimum Storage Temperature
-20 °C
Maximum Storage Temperature
70 °C
Timing/Triggering/Synchronization
Triggering
Digital
,
Analog
Triggers cDAQ Chassis
No
You have selected United States as the country where you will use the product(s)
(change).
Extended Warranties
National Instruments designs and manufactures all products to minimize failures, however unexpected failures can still occur. Extended warranties provide a fixed economical price at the time of system purchase, covering any repair costs for up to three years. In addition, they offer the following benefits:
Significant cost savings compared to individual repair incidents
Fault location, diagnostics, and repair by NI any time the system product fails
All parts and labor costs covered as well as any adjustments needed to restore the hardware to manufacturing specifications
NI recognizes the need to maintain properly calibrated devices for high-accuracy measurements. NI provides manual calibration procedures, services to recalibrate your products, and automated calibration software to calibrate many NI measurement products.
Return your registered product under warranty at no additional labor and parts cost. NI offers fault location, diagnostics, and repair any time the system fails as well as any adjustments needed to restore the hardware to manufacturing specifications.
