Category(s) Selected [start over]

KnowledgeBase [see results below]. To refine your results, select another category.

Getting started with the NI GPIB-485CT-A in serial mode I have configured my NI GPIB-485CT-A in serial mode. I have connected a GPIB device but am unable to communicate with this GPIB device. Can you please help? URL: http://digital.ni.com/public.nsf/allkb/E240FF1B748399D38625734B00272FB0

Why Does My GPIB-USB-HS Device Prompt the Add Hardware Wizard Each Time I Plug it in? Every time I unplug my GPIB-USB-HS device and plug it back in, the Add Hardware Wizard pops up and re-installs the drivers. Each time this happens I lose all of the device configuration settings. How can I avoid this? URL: http://digital.ni.com/public.nsf/allkb/13B27DA885E3F3D2862572CA0065FF70

什么是以太网交路线（Ethernet crossover cable）？ 当我使用NI的以太网硬件时，我被告知我必须使用以太网交路线。那什么是以太网交路线呢？ URL: http://digital.ni.com/public.nsf/allkb/BEDFDAE7C80842B348257258002C54F3

使用NI GPIB硬件与HP5890通讯 我有一台HP 5890，想通过GPIB与它通讯。我使用Agilent的ChemStation软件编程，以及NI GPIB接口，是否可行？ URL: http://digital.ni.com/public.nsf/allkb/AAA08E554D1313B148257209002640EE

在LabVIEW中如何同时控制在同一总线上的多个GPIB设备 我想在同一总线上同时对两个不同的GPIB设备进行测试，在LabVIEW中实现有什么好方法？ URL: http://digital.ni.com/public.nsf/allkb/72AA5BB8B60F3BC4482571EF00434F1F

Acquiring an IP Address for a GPIB-ENET Ideally, you should ask your network administrator to provide you with an IP address for your GPIB-ENET. The alternative is to assign one yourself, which could cause conflicts if you use an IP address that is already claimed by another resource on the network. URL: http://digital.ni.com/public.nsf/allkb/C638CFA25D45D954862571E90070E3ED

Assigning an IP Address to a GPIB-ENET under Windows NT/2000 If the Ready light is steady, then your GPIB-ENET is now ready for use. If the Ready light is not steady after 10 seconds, then repeat steps 2 through 6. URL: http://digital.ni.com/public.nsf/allkb/AA83FDA112499674862571E9006868D9

GPIB-ENET Installation and Configuration under Windows NT You are now ready to connect instruments to the GPIB-ENET and communicate with them. See the Introduction to the Interactive Control (IBIC) page for more information. URL: http://digital.ni.com/public.nsf/allkb/835DA82E6E5E0671862571E90067929C

GPIB-ENET and Windows 3.1 - Firmware Update Utility I have an old GPIB-ENET device that I am using on Windows 3.1. How do I update the GPIB-ENET firmware so that I can use it with the NI-488.2 driver? URL: http://digital.ni.com/public.nsf/allkb/B335707BF8B40EF0862571BE00478D83

Communicate With an HP 5890 Using NI GPIB Hardware I have an HP 5890 and want to communicate to it through GPIB. I will be using Agilent's ChemStation software for programming and would like to use a NI GPIB Interface. Is this possible? URL: http://digital.ni.com/public.nsf/allkb/122F2F9080BD8424862571BC005508D4