Category(s) Selected [start over]

KnowledgeBase [see results below]. To refine your results, select another category.

Why Do My [c]FP-TC-120 Modules Keep Failing Calibration? I am using Calibration Executive to check the calibration of my [c]FP-TC-120 modules. Every time I run the test, all of my thermocouple modules fail the negative tolerance test. I found this suspicious, so I looked into the specifications. For the 20mV test, the pass/fail limit is +/-10uV but URL: http://digital.ni.com/public.nsf/allkb/2E444F0A014D4B95862572A30068CC27

Baud Rate Settings When Calibrating an FP-TC-120 with Calibration Executive What baud rate should I set on my FieldPoint controller in order to calibrate my FP-TC-120? URL: http://digital.ni.com/public.nsf/allkb/8F0CB5E601E4D90B86256F3500673843