Introduction to Mechatronics
Print
This short course from Washington State University uses LabVIEW to introduce students to the basic concepts of Mechatronics. Each exercise requires the student to develop their own solution and gives them hands-on experience with measurement, control, and analysis of mechatronic systems.
DISCIPLINES
Electrical Engineering, Mechanical Engineering
RECOMMENDED TEXTBOOKS
Introduction to Mechatronics & Measurement Systems, Alciatore/Histand, McGraw-Hill, 0-07-240241-5
Mechatronics: Electronic Control Systems in Mechanical Engineering, Bolton, Prentice Hall, 0-582-35705-5
Mechatronics, Necsulescu, Prentice Hall, 0-201-44491-7
TABLE OF CONTENTS
Lab 1 - LabVIEW Introduction
Lab 2 - Proximity Warning System
Lab 3 - Stepping Motor Control
Lab 4 - Servo Motor Control
Lab 5 - Fourier Series and the FFT
Filename: solutions.zip
Application Software: LabVIEW Full Development System 6.1
Language(s): LabVIEW
Hardware Group: Multifunction DAQ (MIO)
Driver: Traditional NI-DAQ (Legacy) 6.9.2
Filename: 4263.zip
Application Software: LabVIEW Full Development System 6.1
Language(s): LabVIEW
Hardware Group: Multifunction DAQ (MIO)
Driver: Traditional NI-DAQ (Legacy) 6.9.2
DISCIPLINES
Electrical Engineering, Mechanical Engineering
RECOMMENDED TEXTBOOKS
Introduction to Mechatronics & Measurement Systems, Alciatore/Histand, McGraw-Hill, 0-07-240241-5
Mechatronics: Electronic Control Systems in Mechanical Engineering, Bolton, Prentice Hall, 0-582-35705-5
Mechatronics, Necsulescu, Prentice Hall, 0-201-44491-7
TABLE OF CONTENTS
Lab 1 - LabVIEW Introduction
Lab 2 - Proximity Warning System
Lab 3 - Stepping Motor Control
Lab 4 - Servo Motor Control
Lab 5 - Fourier Series and the FFT
Requirements
Filename: solutions.zip
Software Requirements
Application Software: LabVIEW Full Development System 6.1
Language(s): LabVIEW
Hardware Requirements
Hardware Group: Multifunction DAQ (MIO)
Driver: Traditional NI-DAQ (Legacy) 6.9.2
Software Requirements
Application Software: LabVIEW Full Development System 6.1
Language(s): LabVIEW
Hardware Requirements
Hardware Group: Multifunction DAQ (MIO)
Driver: Traditional NI-DAQ (Legacy) 6.9.2
Reader Comments | Submit a comment »
Legal
This example program (this "program") was developed by a National Instruments ("NI") Applications Engineer. Although technical support of this program may be made available by National Instruments, this program may not be completely tested and verified, and NI does not guarantee its quality in any way or that NI will continue to support this program with each new revision of related products and drivers. THIS EXAMPLE PROGRAM IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND AND SUBJECT TO CERTAIN RESTRICTIONS AS MORE SPECIFICALLY SET FORTH IN NI.COM'S TERMS OF USE (http://ni.com/legal/termsofuse/unitedstates/us/).